PACTape is a reliable solution for corrosion protection, designed to safeguard pipes, rods, and metal fittings in various environments. Proper installation of PACTape is essential to ensure optimal performance and longevity.

This article provides a step-by-step approach to installing PACTape, helping you to achieve the best results in protecting your metal components.

Step 1: Gather the Necessary Materials and Tools

Before you begin, make sure you have all the required materials and tools on hand. You will need:

• PACTape rolls
• A wire brush or sandpaper
• Cleaning solvent
• Gloves
• Scissors or a sharp knife
• Measuring tape
• Primer

Step 2: Prepare the Surface

Start by preparing the metal surface that will be wrapped with PACTape. Use a wire brush or sandpaper to remove any rust, dirt, or debris from the surface. This step is crucial as it ensures the tape adheres properly and provides effective corrosion protection. Next, clean the surface with a solvent to remove any grease, oil, or residues. Allow the surface to dry completely before proceeding to the next step.

Step 3: Apply Primer 

Some PACTape products may require a primer for better adhesion. Check the manufacturer’s instructions to determine if primer application is necessary. If it is, apply a thin, even coat of primer to the prepared surface and allow it to dry as per the recommended drying time.

Step 4: Measure and Cut the Tape

Measure the length of tape needed to cover the metal surface. It’s advisable to cut a slightly longer piece to ensure complete coverage. Use scissors or a sharp knife to cut the PACTape to the desired length.

Step 5: Begin Wrapping the Tape

Start wrapping the tape around the metal surface, ensuring that the tape overlaps itself by at least 50%. This overlap is essential for providing a tight seal and effective corrosion protection. Apply the tape with firm pressure to eliminate any air pockets and ensure proper adhesion.

Step 6: Continue Wrapping and Overlapping

Continue wrapping the tape around the entire surface, maintaining consistent tension and overlap. For buried pipes or metal fittings, ensure that the tape covers all exposed areas, including joints and welds. This comprehensive coverage prevents moisture and corrosive elements from penetrating the protected surface.

Step 7: Smooth Out the Tape

After wrapping the entire surface, use your hands to smooth out the tape, ensuring there are no wrinkles or bubbles. This step is crucial for creating a uniform, tight seal that offers optimal corrosion protection.

Step 8: Inspect and Test the Wrap

Once the wrapping is complete, inspect the taped surface for any gaps, wrinkles, or missed spots. Address any issues by applying additional tape as needed. For added assurance, you can perform a simple water immersion test or an adhesive strength test to ensure that the tape is securely in place and provides the desired level of protection.

Step 9: Secure the Ends

To finalise the installation, secure the ends of the tape with additional adhesive or a small strip of tape to prevent it from unraveling. This step is especially important for applications involving buried pipes, where soil and moisture can affect the tape’s integrity over time.

Step 10: Regular Maintenance and Inspection

Regularly inspect the taped surfaces to ensure the PACTape remains intact and effective. Look for signs of wear, damage, or loosening, and address any issues promptly to maintain optimal corrosion protection.

At WQ Trade, we take pride in our manufacturing process, producing high-quality Petrolatum Anti-Corrosive Tape that meets international standards. Our tape stands out even among the most well-known brands in the market. We invite you to experience the difference for yourself. Choose WQ Trade for reliable, top-notch anti-corrosive tape.